Wenko Quadro Vacuum-Loc Hair Dryer Holder

The bathroom accessories from this series are not only convinced by the ease of their attachment, but also by their square design and their shiny, rustproof stainless steel material. They are therefore optimally suitable for wet areas. With the hairdryer holder Quadro, the hairdryer has a permanent, decorative place and is within easy reach every morning. It also has a practical cable or plug holder on the side, thus preventing it from becoming annoyingly entangled. The unique system enables fast, easy, and safe attachment of the accessories to all non-air-permeable and slightly uneven surfaces. The new Vacuum-Loc system consists of a pump and mounting Locs; there is no need for drilling and screwing, and suction pads are also not required. Mounting of the Vacuum-Loc system is child's play with the help of the pump. A vacuum is generated in the Loc by extracting the air using the enclosed pump, and the adapters can be immediately subjected to the load of the accessory. With the Vacuum-Loc system, you can forget products falling off the wall - it is an innovation on the market. Features: Size : 14 x 13,5 x 7,5 m Material: Metal - Stainless Steel Vacuum-Loc- A system offers reliable fixing without drilling you can remove and placed it again and again without leaving residue or marks 1.Cleaning the adhesive surface The selected surface must first be cleaned with a clean, damp cloth. Here it is important that the subsurface is completely dry and above all free from grease when mounting. Therefore, bathroom or household cleaning agents should not be used for pre-cleaning. For best results, clean the mounting area with cleaning alcohol. 2.Fixing the vacuum adapter To attach to the desired surface, simply remove the cap on the front and the protective film of the back of the vacuum adapter. Please ensure that the small arrow is pointing down vertically (in the case of the towel rail, both arrows must point horizontally inwards). 3.Generating a vacuum Press the pump against the Loc and pull out the pump piston until a loud plop is heard. Remove the pump from the Loc, attach the pump piston again and repeat the procedure 3 times. Secure fixing works so easily with the Vacuum suction system from WENKO. 4.Can be immediately subjected to loads After the fourth time of applying the pump piston, the adapter can be immediately subjected to loads and the desired accessory can be hung on. To disassemble, simply press sideways on the valve, thus releasing the vacuum.